How much torque is enough? Step 1 - Seco Seal 37 degree conical seal placed on fitting, ready for assembly
Ready to apply torque: Step 2 - Wrenches hold each piece at the starting point
First torque application: Step 3 – Begin initial torque to spec
Re-torque: Step 4 - After initial torque, wait 15 seconds, then re-torque
Check the visible ring: Step 5 – Sealing ring confirms properly torqued connection
Confirmation of the correct seal: Step 6
Examples of various sizes of SECO7 37 degree Copper Flared Gaskets
Examples of various sizes of SECO7 37 degree Nickel Conical Seals
Example of fitting used with SECO7 37 degree flare washers
This closeup image shows a SECO7 37 degree copper Flared Gasket on a fitting prior to installation.
Tools and fittings needed to successfully install 37 degree SECO7 crush washers
Example of finished assembly after installation of SECO7 conical seal
SECO7 37 degree flare saver operating temperature range

CONTACT US

copy-Secoheader

Bluefittings

You can contact SECO SEALS by calling 714.546.3478 or by filling out the contact form below. Either way, we will get back to you to as soon as possible.

Use this form to request a callback for sales information about Seco Seals gaskets.

A World Leader in Gasket Design Since 1969

Translate »